How to Configure Cisco Unified Mobility in CallManager (CUCM) 6 , 7?

Cisco Unified Mobility helps meet the changing needs of following:

To trace moving people
Call forwarding to other network; call must should go out of GW; unified mobility cannot be within IP Network.
Can only be forwarded to one phone number.
If call not attended on other network, it can come back to IP network.
Can be attended on IP Phone + other network phone at same time.
Unified Mobility is the topic of centralized topology.

CUCM Configuration:

Step 1: (Create two "Mobility" soft keys on ON HOOK & CONNECTED mode)

- Device -> device settings -> softkey template -> add new -> copy any default key template -> rename -> modify -> Configure Softkey Layout [drop down-right top corner] -> Go

- On Hook Mode -> Mobility -> Connected Mode -> Mobility -> save

Step 2: (Create User)

- Cisco Unified CM Administration -> User Management -> End User -> Add New ->

- User = "ki123", password, PIN, last name etc

- Mobility Information -> Check Enable Mobility -> Save

Step 3: (Call Soft key on Phone)

- Device -> Go inside phone -> softkey template -> select newly created key "Mobility"-> save -> reset phone

Step 4:

- Device -> Device Settings -> Remote destination profile -> Add New -> Enter Name "Remote_Destination" -> User ID Select (who needs unified mobility) -> Device Pool select (optional) -> new window will appear -> Add DN (DN on which mobility will be associated) -> Add New DN -> Save

Step 5:

- Device -> Remote Destination -> Add New -> "Remote_Destination_Info"

- Destination number = 09118890043

- Remote Destination Profile -> Select "Remote_Destination"

- Check Mobile Phone

- Save -> A new window will appear

- Association Information -> Line Association -> Check the box -> Save

Step 6:

- Call Routing -> Route/Hunt -> Route Pattern -> Add New

- Route Pattern 0911889004

- Gateway/Route List -> Select GW -> Save

Suggested Reading