COMPUTER TIPS
How to Connect "Non Zero Area" to "area 0" via tunnelling in OSPF?
In multi-area OSPF network, all areas should be connected physically with area 0 (backbone area) for exchanging routing information and keeping routing table to date. Under certain cases, it is not possible to connect directly all areas in a network to backbone area. In this case, one can use virtual link to create a connection between backbone area and non backbone area. Virtual link is a logical connection to create virtual adjacency between two areas.
Two conditions must be fulfilled in order to configure a virtual link between different areas.
- One area must be area 0 (backbone area).
- One area must be common between two endpoint routers to create virtual links.
When we are talking about virtual links then another advanced form of virtual link is tunnelling. Tunnelling is normally being used in the complex network scenarios.
Lets take the example of following topology in Fig 1 in which consists of three routers. We can see how the router interfaces are connected to different areas. Routers R2 and R3 has interfaces which fall under the area 2 and they are not connected to the area 0.
Configuration of Tunnel
Configure and assign IP addresses to all of the router interfaces and configure them under the areas as depicted in the Fig 1.
When we will run “show ip route” command on router R0, it is not displaying the route to 3.0.0.0 network, shown in the Fig 2.
Fig 2. Result of show IP route and ping to 3.1.1.1
On the other hand, the result of “show ip route” and ping to 1.1.1.2 can be seen on router R3 in the Fig 3. You will notice that show IP route is only displaying the 3.0.0.0 network.
Fig 3: Result of show IP route and ping to 1.1.1.2 on router R3
Configuration of Tunnel needs following series of commands.
R(config)# interface tunnel 0
R(config-if)# ip address {ip address} {net mask}
R(config-if)# tunnel source {source ip address}
R(config-if)#tunnel destination {destination ip address}
Configure the OSPF for the network addresses of the tunnels.
Fig 4 and Fig 5 shows the configuration of tunnels on the routers R1 and R2 respectively.
Fig 4: Configuration of tunnel on R1
Fig 5 : Configuration of tunnel on R2
After the successful configuration of the tunnelling we will notice in Fig 6 that on the router R3, ping was successful to 1.1.1.2 and R3 was showing all other networks as well, previously it was displaying only 3.0.0.0 network.
Fig 6: Result of “Show ip route” and ping to 1.1.1.2 on router R3
Break or recover the router passwordSuggested Reading
How to configure the Cisco IOS IDS step by step?
Routing Information Protocol (RIP) Configuration
How to configure site-to-site VPN tunnel using ASA?
How to install Router image using TFTP server?
New
How to protect EIGRP router from receiving unsigned routing updates?
How to configure BGP between two different autonomous systems?
How to configure virtual link between different areas in OSPF?
How to perform unequal-cost load balancing using EIGRP?
How to configure Site-to-Site IPsec VPN?
How configure EIGRP authentication to prevent unauthorized access?
How to configure BGP with weight attribute?
How to perform configuration and convergence between RIP and IGRP protocols?
Interior Gateway Routing Protocol (IGRP) Configuration
Extended IP Access Control List
Enhanced Interior Gateway Routing Protocol (EIGRP) Configuration
Useful Router commands and configuration Common Frame Relay Configuration
Home | Previous Page | Site Map | About Us
