COMPUTER TIPS

How to perform SIP Server Configuration?

 

 

 

 

Router A

 

Sip-ua

 Sip-server ipv4:192.168.0.200

             Exit

 

Dial-peer voice 1 pots

            Application session

            Destination-pattern 101

Port 1/0/0

            Exit

Dial-peer voice 2 pots

 Application session

 Destination-pattern 102

 Port 1/0/1

             Exit

 

Dial-peer voice 3 voip

          Application session

          Destination-pattern 20.

          Session protocol sipv2

          Session target sip-server

 

Router B

 Sip-ua

 Sip-server ipv4:192.168.0.200

             Exit 

 

Dial-peer voice 1 pots

            Application session

            Destination-pattern 201

Port 1/0/0

            Exit

 

Dial-peer voice 2 pots

 Application session

 Destination-pattern 202

 Port 1/0/1

             Exit

 

Dial-peer voice 3 voip

            Application session

            Destination-pattern 10.

Session protocol sipv2

            Session target sip-server

 

 

SIP Server Registration

Register Router A Phone

 

Register Router B Phone

 

Now 101 and 201 are registered on SIP Server

 

       

Suggested Reading

•  Break or recover the router password

•  How to configure the Cisco IOS IDS step by step?

•  Routing Information Protocol (RIP) Configuration

•  Point-To-Point Leased Line Implementation

•  How to perform SIP Server Configuration? New

•  How to configure Stub area in OSPF protocol?

• How to configure site-to-site VPN tunnel using ASA?

•  Router basic Troubleshooting Tips

• How to configure Remote Access VPN using ASA?

• How to perform route summarization using BGP protocol?

• How to install Router image using TFTP server?

• How to protect EIGRP router from receiving unsigned routing updates?

 

• How to configure Role-Based CLI Access using Cisco IOS?

• How to configure BGP with local preference attribute?

• How to configure Dynamic Multipoint VPN (DMVPN)? New

• How to configure Totally Stub Area in OSPF protocol?

• How to perform route summarization in OSPF protocols?

• How to configure BGP between two different autonomous systems?

• How to configure virtual link between different areas in OSPF?

• How to perform unequal-cost load balancing using EIGRP?

•  How to configure Site-to-Site IPsec VPN?

• How configure EIGRP authentication to prevent unauthorized   access?

• How to configure BGP with weight attribute?

•  How to configure OSPF step by step?

• How to perform configuration and convergence between RIP and IGRP protocols?

•  How to configure OSPF with multiple areas?

 

•  Interior Gateway Routing Protocol (IGRP) Configuration

•  Extended IP Access Control List

•  Enhanced Interior Gateway Routing Protocol (EIGRP) Configuration

•  Useful Router commands and configuration

•  Standard IP Access Control List

•  Common Frame Relay Configuration

•  Integrated Services Digital Network (ISDN)